Bedside Wall Lights Acrylic

  • Input voltage:100-240VAC 50/60Hz.
  • LED Driver: constant current driver, stable quality.
  • LED Chips: High lumens SMD LED Chips,80-90lm/W.
  • Materials: Aluminum base+acrylic body, White/Black housing optional.
  • IP Grade: IP22 non-waterproof, indoor use only
  • Color temperature:3000K Warm white;4000-4500k natural white,6000-6500K cold white.
  • Working life:50000Hrs.
  • Storage temperature:-30℃~50℃,10%~90% R.H.
  • Working temperature:-25℃~45℃,10%~90% R.H.
  • Warranty:2-3Years

You can make an inquiry about this product.
Your e-mail will not be leaked.


This wall light is made of acrylic materials and a small aluminum base, it is very suitable for the bedside. When the wall light fixtures are turned on, the light can pass through the acrylic, emitting a faint soft light, creating a comfortable resting environment for the bedroom. What is more, from cost, this series is much more competitive than indoor wall lights made by die-cast aluminum. And its volume is very small, the small sconces will be only less shipping cost, especially for international shipping.


ModelPowerDimensionMaterialColor temperatureLumensInput voltageWorking Life
GR-WML-6WD6W290*110*50mmAl base+acrylic body3000k-6500k480-540lm100-240VAC 50/60Hz>50000Hrs


  1. High-Quality Acrylic body materials, High light transmission, low cost.Not easy to yellow changing.
  2. Famous driver brand, lifespan up to 50000Hrs.working life more than 10years at least. and Free flicker.
  3. Epistar /Samsung chips.High CRI, low light decay, good color capacity, good light color consistency
  4. Dimmable option(Triac dimmable/1-10V dimmable), it is better for you to control light and save much more energy
  5. Different color for base optional as following

Installation way for bedside wall lights

Open the package and take out the lamp body and accessory package, loosen the two screws on the side of the base, and remove the hanging plate. According to the hole position of the hanging plate, make a hole at the position where the wall needs to be installed. And drive the glue nail into the hole. Then use self-tapping screws to fix the hanging plate on the wall. And confirm that the hanging board is firm and reliable

Then connect the lamp body wire with the mains wire and make insulation protection. Align the holes on the upper side of the lamp body with the screw holes on the hanging plate, and then tighten the screws.


1.What color temperature is better for bedside wall lights?

For LED wall mounted bedside lights, the color temperature is very important. It is best to use warm white 2800-3000K, which looks very soft and warm, can relax people, and make it easier to fall asleep. And sometimes, it is also good for reading.

2. What is the Installation height of bedside wall lamp?

Generally, It is the best to install at a place 20-30 cm higher than the bedside.

Related Product



Similar Posts